Master Lock XR20 Manual de servicio descargar pdf (Pagina 71)

initiate continuous is enabled (INIT:CONT ON), the trigger subsystem immediately re-initiates

itself after ABORt, thereby setting WTG. ABOR is executed at power turn on and upon

execution of *RCL or *RST.

Command Syntax: ABORt <>

Examples: ABOR

Query Syntax: None

Related Commands: INIT, TRIG, *RCL, *RST

4.3.7 Trigger Subsystem

This subsystem controls remote triggering of the power supply. When the trigger subsystem is

enabled, a TRIG command generates a trigger signal. The trigger signal will then initiate a

pending level change as specified by CURR[:LEV]:TRIG or VOLT[:LEV]:TRIG. Afterwards,

the Operation Register will be cleared. If INIT:CONT is on, the trigger subsystem is immediately

re-enabled for subsequent triggers. As soon as it is cleared, the WTG bit is again set to 1.

Command Syntax: TRIGger[:IMMediate] <>

Examples: TRIG

TRIGGER:IMMEDIATE

Query Syntax: None

Related Commands: ABOR, CURR:TRIG, INIT, *TRG, VOLT:TRIG

4.3.8 Initiate Subsystem

This subsystem enables the trigger system. When the initiate subsystem is enabled, a TRIG

command allows specified triggering action to occur. If the initiate subsystem is not enabled, all

trigger commands are ignored. If INIT:CONT is OFF, then INIT enables the trigger subsystem

only for a single trigger action; INIT must then be repeated prior to further trigger commands. If

INIT:CONT is ON, then the trigger subsystem is continuously enabled.

INIT:CONT? returns the state of the continuous trigger mode.

Command Syntax: INITiate[:IMMediate] <>

INITiate:CONTinuous <bool>

Parameters (for INIT[:IMM]): None

Parameters (for INIT:CONT): 0 | 1 | OFF | ON

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 128 129

Sin comentarios

Master Lock XR20 Manual de servicio Pagina 71